2014 New | MPPT solar controllers | I series solar controllers | S series solar controllers | C Sereis Solar Controllers | V Series Solar Controllers | G Z Sereis Solar Controller
WaterProof Solar Controllers |
48V Solar Controllers | Dual Battery Controllers | Solar Controllers With LED drivers | Accessories | User Manual
Oversea Warehouse - Australia - United States - United Kingdom
CMP-03 5A Mini Waterproof Solar Charge Controller IP66
Introduction£º
The CMP-03-Series solar charge controller applies a microchip for intelligent control.The
charging efficiency can be highly increased by using dual-mos charging circuit ,compared to normal
diode for reserve current protection. The controller can extend the battery life with build-in 4-stage PWM
charging program.It is equipped with various of protection function such as over-charge protection,over
discharge protection ,over-load protection,reverse current protection.
Function:
1. Prevent the battery from over charging, over discharging and Reverse discharging to solar panel during nights.
2. Controller will start the lighting system in the evening automatically according to the surrounding luminance.
3. Controller can automatically shut down the lighting system:
A: Automatically shut down the light at dawn when battery is full.
B: Automatically shut down the light when battery is low.
Notice:This product has light and time control.
Light control:When daylight starts to occur then the light source goes off. Meanwhile the
Solar Panels will charge the batteries. when there is no sunlight the garden light will switch on. Time control:There is an eight hours time control,that means it will go off when the Lights
automatically switch off after 8 hours.
|
Green(charge£© |
Red£¨discharge£© |
off |
Solar panel disconnect /it is at night |
Load output is off |
on |
Under PWM charge |
Load output is on |
Slow-flashing |
Under float charge |
Over load |
Fast-flashing |
Under buck charge |
N/C |
Data Sheet
Model |
CMP-03-5A |
Max charge current |
5A |
Max charge current |
5A |
Over load |
About 6A |
Rated battery voltage |
6V |
Max solar panel input voltage |
10.8V |
Equalize voltage |
7.4V |
Constant voltage |
7.1V |
Float voltage |
6.9V |
LVD |
5.6V |
Discharge return |
6.3V |
Charging control |
PWM 3 stage |
Standby lost |
2.8mA@6V |
Min start voltage |
4.5V |
wire |
20AWG*10cm |
Size/weight |
60x25x18mm/50g |
CMP-03 10A Waterproof Solar Charge Controller 12V IP66
Introduction£º
The CMP-03-Series solar charge controller applies a microchip for intelligent control.The
charging efficiency can be highly increased by using dual-mos charging circuit ,compared to normal
diode for reserve current protection. The controller can extend the battery life with build-in 4-stage PWM
charging program.It is equipped with various of protection function such as over-charge protection,over
discharge protection ,over-load protection,reverse current protection.
1.Build-in industrial micro controller. 2.LED display,auto memory function,IP68 protection. 3.Fully 4-stage PWM charge management. 4.Build-in short-circuit protection,open-circuit protection,reverse protection,over-load protection. 5.Dual MOSFET Reverse current protection ,low heat production.
Function:
1. Prevent the battery from over charging, over discharging and Reverse discharging to solar panel during nights.
2. Controller will start the lighting system in the evening automatically according to the surrounding luminance.
3. Controller can automatically shut down the lighting system:
A: Automatically shut down the light at dawn when battery is full.
B: Automatically shut down the light when battery is low.
The mode has been set inside the controller before exit the factory.Do ask for further more information from your distributor.
mode |
description |
Charge only |
Only use the charge function of the controller. Load output is forever closed |
Light-open+delay |
Load on after sunset and closed after 1-13hour |
D2D |
Dusk to Dawn£¨have delay£© |
System |
Load always output£¨unless battery is low£© |
debug |
Dusk to Dawn£¨no delay£© |
Data Sheet
MODEL |
CMP-03 10A |
CMP-03 20A |
Batt voltage |
12V/24V auto adapt |
|
Charge current |
10A |
20A |
Discharge current |
10A |
20A |
Max Solar input |
41V |
|
Charge drop |
<0.2V |
|
Discharge drop |
<0.25V |
|
Equalization |
14.8V |
|
Bulk |
14.5V |
|
Acceptance |
14.2V PWM |
|
Float |
13.8V |
|
Charge reconnect |
13.0V |
|
Discharge stop |
11.2V |
|
Discharge reconnect |
12.6V |
|
Self-consume |
<10mA |
|
Voltage of open light |
Solar panel 8V£¨delay 10s£© |
|
Voltage of close light |
Solar panel 8V£¨delay 60s£© |
|
Temperature compensation |
N/C |
|
Operating temperature |
-35~+60 ℃ |
|
Size/Weight |
82*45*21mm /120g |
LS1024RP,LS2024RP 10A 20A Waterproof Solar Charge Controller
The controller is Ideal for extreme environments with corrosion, dust, water etc
|
|
|
|
Features£º
¡¤Waterproof design
¡¤High efficient Series PWM charging
¡¤Gel, Sealed and Flooded battery type option
¡¤Widely used, automatically recognize day/night
¡¤Intelligent timer function with 1-15 hours option
¡¤Use MOSFET as electronic switch
¡¤Digital LED menu with simple setting and easy using
¡¤Temperature compensation
¡¤Reverse protection: any combination of solar module and battery
Electronic Protections:
¡¤Overheating
¡¤Over discharging
¡¤Over charging
¡¤Load overload
¡¤Load short circuit
¡¤PV short circuit
¡¤PV reverse polarity
¡¤Battery reverse polarity
Data Sheet
Electrical parameters |
LS1024RP |
LS2024RP |
Nominal System Voltage |
12 / 24VDC auto work |
|
Rated Battery Current |
10A |
20A |
Max. Battery Voltage |
32V |
|
Charge Circuit Voltage Drop |
¡Ü0.26V |
|
Discharge Circuit Voltage Drop |
¡Ü0.15V |
|
Self-consumption |
¡Ü6mA |
|
Overall dimension |
145 x 69 x 31mm |
145 x 85x 34mm |
Wire diameter |
4mm2 |
6mm2 |
Net weight |
0.3kg |
0.4kg |
Working temperature |
-35¡æ to +55¡æ |
|
Humidity |
10%-90% NC |
|
Enclosure |
IP66 |
Battery Voltage Parameters (temperature at 25¡æ) |
|||
Battery charging setting |
Gel |
Sealed |
Flooded |
Equalize Charging Voltage |
¡ª¡ª |
14.6V;x2/24V |
14.8V;x2/24V |
Boost Charging Voltage |
14.2V;x2/24V |
14.4V;x2/24V |
14.6V;x2/24V |
Float Charging Voltage |
13.8V;x2/24V |
13.8V;x2/24V |
13.8V;x2/24V |
Low Voltage Reconnect Voltage |
12.6V;x2/24V |
12.6V;x2/24V |
12.6V;x2/24V |
Low Voltage Disconnect Voltage |
11.1V;x2/24V |
11.1V;x2/24V |
11.1V;x2/24V |
Equalize Duration |
¡ª¡ª |
2 hours |
2 hours |
Boost Duration |
2 hours |
2 hours |
2 hours |
Copyright© YSmart Technology Co.,Ltd .2009-2014 Powered by ChinaSolarRegulator.com